IR Remote Controller Stepper Motor With TB6560 Board

Motor parameters
Motor diameter 28 mm
Output journals] Double D-axis maximum diameter of 5 mm, the narrowest of 3 mm
[Motor Torque] Unknown, item 350g on the original shaft is easy to pull up
Motor voltage 4.2-5.1V
[Procedure] 6.25 * 1/64
[Reduction ratio] 1:64
Drive plate volume L25xW18xH13 mm
Driver board supply 4.2-5v DC
Driver board starting current 1000mA

Driver board function
* Full infrared remote control operation more convenient
* Small size L25xW18xH13mm very easy to place
* Adjustable speed: from 1 second to 59.99 seconds (+ - sign)
* Reversal control (ch-; ch +)
* Start stop control (CH); press again to stop; this site includes all other cruise modes of operation etc.
* Specify the number of steps: If the input value is greater than 65535 times 65535, the key input is at the beginning of the 6-digit setting 2. Set each button 100 + / 200 + forward / reverse to run the set number of steps
* Cruise times: press the numeric keys to enter 3-digit prefix 6-digit number; for example, cruise 3 times input: 300003. The maximum number is 65534 times, and the value exceeds this value and runs through infinite loop. After the pause button set the run, according to the cruise operation, then off by cruise
* Auto mode: Specify the set number of steps and cruise times, press the "||" to suspend the button to start the reciprocating movement to specify the number of automatic reversal cycles until stopped again with the "||" button (take the remaining stops Number of stops) or the number of cruise completions. If you can not clearly state that you did not turn on autorun, you can press the CH button twice;
* You can enter the number 00001-59999 directly from the keyboard speed (Note: 0.5 is 1000 milliseconds)
* Each memory, all with memory
* When each switch on the motor is to be reversed automatically, limited control of the upper limit switch will be automatically reversed: for example, the distance between A and B is running, so A and B are each placed with a switch A wiring switch is parallel) Because the motor will enter A reverse B, then reverse