KQ-130F Power Line Carrier Module

KQ-130F is a chip carrier based on independent research and development and production of high-performance single 9-pin small volume zero carrier data transceiver module. Is designed for 220V AC, strong interference, strong attenuation, in harsh environments, long-distance, reliable data transmission and specially designed high-cost carrier module development. KQ-130F carrier module includes a carrier driver, coupling, filtering, lightning and many other complex peripheral circuits. The user only needs to provide a 5V power supply. The two signal lines (TX, RX) are connected to the MCU via two end modules directly connected to an AC 220V (no matter live wire or neutral wire) Send and receive data. KQ-130F carrier module for measurement, road lighting, smart home, fire safety, building control and other applications require the transmission of power line data. Transmission distance up to 1.5Km.
?????
???????KQ-130F Series Zero Carrier Data Transceiver Module is based on the true meaning of zero modulation and demodulation carrier module. Anti-interference ability, transmission distance is far superior to the market so-called zero-crossing module.
First, KQ-130F series of performance:
1. The integration of the KQ-330F module and the carriers peripheral circuits eliminates the need for additional coupling elements and is directly connected to 220Vac. Dimensions are 53 × 38 × 17mm (L × D × H), single-pin lead (see below) 1, 2 pin connection 220V AC power supply No direction (1 foot, 2X0.1 inches 2 feet), 2 feet , A pitch of 3 feet and 1.1 inches, and a pitch of 0.1 inches between the rest of the feet.
2. Operating frequency 120 ~ 135KHZ, interface baud rate 9600bps. The actual baud rate is 100bps.
Redundant data maximum continuous transmission length ≤252 bytes, continuous transmission of a user-defined length of 1-252 frames, the module does not send the frame 3
4. Receiving sensitivity ≤ 1mV
5. With resistance ≥ 60 dB
6. Bandwidth ≤ 10KHZ
Insulation resistance 500V≥500MΩ
8. Power: DC + 5V when receiving: ≤ 230mA when ≤ 11mA
9. Power frequency withstand voltage: AC 3000V ground between 1min without breakdown test, no leakage current.
10. Lightning Protection: TVS tube protection within the board, from the layout of the PCB board to choose the part of the choice of the impact of design choices, with temperature, high voltage, high voltage characteristics.
11. Operating temperature: -25 ° C ~ 70 ° C Humidity ≤ 90%
?
?
1P-AC: 220V AC voltage hot line (or neutral)
2P-AC: 220V AC voltage zero line (or FireWire)
3P- + 5V: + 5V power supply (210mA), if the received data can be left alone to reduce power consumption

4P-GND: Digital circuit ground
5P- + 5V: + 5V Supply current 11mA, the minimum operating voltage of 3.3V, but it is not recommended
6P-RX: TTL level, data carrier, then MCU TXD
7P-TX: TTL level, data carrier, then MCU RXD
8P-MODE: mode selection, vacant or then 5V, high, low ground
9P-NC / RST: The reset pin (active low) is frequently used in switching mode. This function should be left blank